 |
Did the NADCA member show proof of membership and certification?
|
|
|

|
Did the contractor conduct a thorough inspection of your system PRIOR to performing any work and alert you to any problems? This is required by the current NADCA ACR Standard.* |
|
|

|
Did the member company visually demonstrate to
your satisfaction that the following
was accomplished?: |
|
Cleaned Supply Ductwork |
|
|
Cleaned Return Air Ductwork |
|
|
Removed, Cleaned and Replaced: |
|
|
- Supply Registers |
|
|
- Return Air Grills |
|
|
Accessed and Cleaned: |
|
|
- Supply Air Plenum |
|
|
- Return Air Plenum |
|
|
Installed Access Panels as Needed |
|
|
Removed, Cleaned and Reinstalled: |
|
|
- Blower Motor & Assembly |
|
|
Cleaned Airstream Side of Heat Exchanger |
|
|
Cleaned Secondary Heat Exchanger |
|
|
Cleaned Evaporator Coil, Drain and Pan |
|
|
Method 1: Wet clean in Place |
|
|
Method 2: Remove, Wet Clean & Replace |
|
|
Method 3: Air Wash in Place |
|
|
Replaced Air Filter |
|
|
Washed Air Cleaner |
|
|
|
If no to any of the services listed above, why not?
|
|
|

|
Did the system work properly after the cleaning? |
|
|
| *Please note: Cleaning the cooling coils is required by the NADCA Standard – Assessment, Cleaning & Restoration of HVAC Systems (ACR). However, some state regulations specify that only HVAC contractors may clean cooling coils. Be certain to ask your NADCA member company representative if his/her company will clean the coils of your HVAC system. |
 |
 |
 |
 |
 |
 |